Industrial Plants With Clean Room Blue Sticky Floor Mat Dust Removal Anti Static

Industrial Plants With Clean Room Blue Sticky Floor Mat Dust Removal Anti-Static

Product description

Sticky mat actual there are 32 layer, there are 30 layer left or lower right corner has 1 to 20 or 30 to 1, in order to change, the first layer is no plastic transparent PE film + 29 layer coating PE film (usually blue or white, other color can be customized) + 1 layer coating double sky-blue PE protection compound and into, double the mask of the first layer is the sky blue, with 30 or above 1 digital label, without glue layer 2 is transparent PE film and glue layer PE film on each floor with 1-29 or 29-1 digital label.

Detailed parameters

The base materia	35 ~ 50 mu m thick coating PE
The gluing thickness	5～7μm
The layer number of the product	30 / piece
The thickness of the product	1.55～1.8 mm/
Product color	Blue or white
Dedusting effect	99.9%
180 degree stripping strength	300g-350g / 25mm (gb2792-98) viscosity increases or decreases
At the beginning of viscous fluid	> 50mm (gb4852-2002 stickiness test method, ball bearing method)
A viscous	1440(24h)(GB4851-98)
Product specification	18″×36″,24″×36″ ,24″×45″,26″×45″
Remark: the specification can be made according to customer's requirement.

Features:

1. Soft material: The surface is very smooth and has a microscopic surface, which can be easily glued to the surface to contact with different sizes of dust, especially the uneven small concave parts of the sole and wheel.
2. Easy to clean: can be cleaned with water or alcohol, wood
3. The material is non-toxic, environmental protection, practical use effect is good, without any side effects.
4. The adhesive pad can be used alone or in combination with the frame. The bottom pad can be removed, leaving no trace and not polluting the environment.

Usage 

This product is composed of 30 layers of PE film, with 1-30 # in the lower left corner of each layer for replacement. When using, first remove the protective layer from the opening at the back of the surface, and then place the flat surface on the clean and non-watermark floor. And along the edge of emulsion with sole pressing, and then from the positive opening off protective layer, so you can use, if you use in the process of the surface of the film adhesive is full of dust, just scraped through opening this layer, so that you can use the next layer of the pure film.

Schematic diagram for cleanroom sticky mats